Hand-held-products Dolphin 7200 User Manual download pdf (Page 34)

5 - 4 Dolphin® 7200 User’s Guide

Dolphin Demo Main Screen

When you start the program, this menu screen will be the first one you see. This screen allows you to access the demonstration

programs listed or exit to DOS. All the Demo programs will return to this menu screen when exited.

If there is no keyboard activity over a short period of time, press any key to go to the Dolphin Demo Main Screen.

F1 - Decoding Demo

Press F1 and the Scan a Target screen shown below will display:

For optimal scanning performance for your application, the 2D imager has three scanning modes: standard omni, reduced omni

and Advanced Linear Decoding (ALD).

To scan a bar code:

1. Press and hold the ON/SCAN button.

2. You will see the scanner alternate between a thin green aiming line, and a general red flash. The flash is when the imager is

actually taking an image and attempting to decode any barcodes in the image.

3. After the Dolphin successfully decodes a barcode, the Decoded Message screen shown below will display.

The top of the screen tells the name of the symbology decoded, the bottom of the screen tells the

length of the data decoded, and the middle section shows the message. If the message is long, you

can scroll up and down using the F1 & F2 keys to read the data. To scan again, just press the ON/

SCAN button again.

3. To exit demo, press F4 and you will return to the Dolphin Demo Screen.

F1-Decoding Demo

F2-Imaging Demo

F3-I.Q. Demo

F4-Exit to DOS

F3-Setup

H-Help

Scan a Target

C7771104501

UPC

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 113 114

No comments

Hand-held-products Dolphin 7200 User Manual Page 34